These bars are 4" taller than stock!! They fit the new Chieftain and are made in the USA!! 1 1/4" tubing and use the stock clutch cable, Available in black or chrome -
opening in the top of the bars is too small to fit the factory wiring setup ,had to remove the factory wire loom and tape the wires up .i cracked a connector pulling the wires though . worst part was having to grind down the gusset on the left side to make enough room to mount the clutch lever clamp assembly. the height of the bars is perfect ! the welds and chrome were beautiful , (until i had to clearance to left side gusset) . i will have these bars re-chromed over the winter after i grind down the right side gusset to match the left one. its a common problem with any after market part, nothing ever fits!