COBRA

PART NO: 04-0468

On February 20, 2009 ggibbs wrote:

Installed on 900 Classic w/ factory shield and MC Ent engine guard w/ no clearance problems whatsoever. Visors are a pain to install, but look great.

On October 27, 2008 pat0021 wrote:

Nice set up, but dont care for thier way of wiring. I added a relay to run the lights off the acc wire in the headlight bucket. The way these lights mount you can't get to the head light screws unless you loosen the lightbar lamps and move them out of the way.

On October 27, 2008 Long Rider wrote:

The light bar is great, however the on/off switch is located in a difficult location to operate while in motion. The switch is on the right side of the bar, and low. In order to operate the switch, you have to reach accross the gas tank with your left hand or let off the throttle with your right hand. Either is not to bad unless your riding 75mph down the highway. Contacted Cobra, they stated that there is nothing they can do about the problem, live with it. Would be a "5" if the switch was mounted in a better location, like on the handle bars.

On October 27, 2008 cargain35 wrote:

Need to do modifications if you want to use with Memphis Fats windshield.

On October 27, 2008 Matt7even wrote:

Some what easy install, Increases night time visability (FOR you and OF you), and looks sharp! The only faults would be the play in the spotlight mounts that can cause them to un-align while riding (rubber washers might fix this). Also installing extra lights without a new relay can cause fuse blowouts. Mine has only blown once so far.

On October 27, 2008 madhats101 wrote:

Love it! It adds soo much more to the look of the bike. If you do alot of night riding, it is a must. I'm no longer scared of what might be in the road ahead, I can see it.