CORBIN PARTS ARE MADE PER ORDER AND PRODUCTION TIME IS 5 TO 8 WEEKS.
Corbin's R&D team took the base from our passenger saddle and engineered a rack setup to extend the footprint of the factory rear carrier. That means you can add a pack in front of your trunk or bring your softbag further forward with the simple twist of a key.
Constructed of 3/16 inch aluminum secured to our rigid Fibertech base material for strength and durability. The laser cut aluminum plate is then coated using spray-on Raptor liner in textured black. Under the rack, the Corbin base is built up with our exclusive Comfort Cell foam that provides a nice bump pad for the rider. Notice how the plate is cut around the bump pad so it makes a natural stop to keep your pack from sliding forward.
Height of the rack was designed to sit level with the passenger grab handles and rear carrier. This extends the platform nicely so you can place a pack in front of your trunk where a passenger would be and use it for back support. Or extend the capacity of the rear carrier to allow for a larger pack that comes forward and leaves less weight cantilevered over the rear tire.
The whole unit locks into place using the factory BMW key lock system for easy installation. Corbin's rear seat rack works with your OEM front seat or with any of Corbin's front saddle models. Naturally we'll coordinate the bump pad and base area to match the design of your Corbin front saddle or OEM unit for an integrated look.
Cover shown above: Black Carbon-Fiber leather seating, Matte Black Sides, Sky Blue welt and Large BMW Corbin logo in Silver. Note, the back of the bump pad and the area under the rack will be made with the same material chosen for "Sides".
There are no community comments or ratings
Review This ItemThis item may be used with the following bikes:
There are no community comments or ratings
Review This ItemThis item may be used with the following bikes: