Point Cut Rear Custom Fender Hand-Spun Steel Choppers
Add an aggressive, stylized edge to your custom build right out of the box.

The Point Cut Rear Fender carries the same clean radius arc as the standard fenders but arrives with a sharp, pointed rear tip that transforms the tail section of any chopper or bobber from plain to purposeful.

Key Features:

Sharp custom point cut on the rear tip – bold, stylized detail added at the factory
Retains the clean radius side profile everywhere else for a balanced overall look
No grinding or reshaping required – the signature tip cut is already done
Hand-spun from 13-gauge U.S. steel with standard 1.75-inch sidewall depth
Ships raw for full control over surface prep, body filler, and paint or powder coat finish

Technical Specifications:

Style: Standard Radius Side with Custom Point Cut End
Material: 13 Gauge U.S. Steel, TIG Welded
Outer Diameter: 27 inches
Sidewall Depth: 1.75 inches
Wheel Compatibility: Optimized for 18-inch motorcycle wheels
Finish: Raw, uncoated hand-spun steel
Origin: Made in the USA

Fitment Notes:

This is a custom fabrication part – not a bolt-on replacement for any specific motorcycle
Requires custom spacers, bungs, or struts for mounting; hardware sold separately
Drilling, welding, and fabrication are required to fit your specific frame width and geometry
Supplied in raw, uncoated spun steel finish; visible spinning lines are normal and expected on hand-spun parts
Apply high-build surfacer or body filler to smooth the surface before painting or powder coating
Optimized for standard 18-inch motorcycle wheels; select fender width by rear tire size

Fender Size:

6 Inch For 130mm Tire
7 Inch For 160mm Tire
7.75 Inch For 170mm Tire
8.5 Inch For 180mm Tire
9 Inch For 200mm Tire
10.5 Inch For 240mm Tire
11 Inch For 250mm Tire
11.5 Inch For 260mm Tire
12 Inch For 280mm Tire
12.5 Inch For 280/300mm Tire
13 Inch For 300mm Tire
14 Inch For 330mm Tire